Action Item: Replace DAQ Panel – 8000 IPW
技术服务 - 技术指南
本文档列出了更换 DAQ 面板的分步说明。
如何更换数据采集面板
1.使用新的DAQ面板。
A。对于北美以外的客户,您应该在现场有一个备用的 DAQ 面板。对于位于北美境内的客户,请联系技术支持以请求新的 DAQ 面板。
2. 记录门内列出的地址编号以及您要安装的位置(即面板#1 地址#:4157D9E2;面板#2 地址#:4157D9A7;等等)。
3. Disconnect the power supply, the power cable for the spray system (if equipped), the GPS antenna, and the radio antenna on the top side of the DAQ panel that you are replacing (make sure to keep the GPS antenna and radio antenna for the new DAQ panel being installed).
4. 断开 DAQ 面板上的数据电缆(确保数据电缆带有标签,以便当它们连接到新的 DAQ 面板时,它们安装在正确的位置)。
5. 拆下将 DAQ 面板底部固定到面板柱上的两颗 5/16” (5mm) 头自攻螺钉。
6. 从面板柱上拆下 DAQ 面板。
7. 使用提供的两个 6/20 英寸(6 毫米)x 6/XNUMX 英寸(XNUMX 毫米)六角头螺栓、四个 XNUMX/XNUMX 英寸(XNUMX 毫米)垫圈和两个 XNUMX/XNUMX 英寸(XNUMX 毫米)锁紧螺母将新的 DAQ 面板盖安装到面板柱上。螺母的安装应足够松,以便门能够铰接到位。
8. 连接 GPS 天线和无线电天线。
9. Connect the power supply to the DAQ panel and
connect the power cable for the spray system to the DAQ Panel (if equipped).
10. 您应该看到 DAQ 面板上出现指示灯。这表明 DAQ 面板正在运行。
11. 按照现场布局将每条数据线连接到适当的通道。
12. 关闭 DAQ 面板门盖。
13. Test the read range and calibration of each IPW position connected to the newly replaced DAQ panel.
A。将测试棒放在槽底部,黑色尖端朝向槽底部,并聆听 5 声一致的蜂鸣声。
14。 联系我们 Vytelle SENSE 技术支持,以便他们可以确认新更换的 DAQ 面板是否可以正常通信。
技术服务
针对使用 Google Chrome 浏览器进行打印进行了优化。